User`s manual

5 REGISTER MAPS
The PCI Controller, a PLX-9052, has four configuration, control, and status registers
(Table 5-1). They are described in the following section.
Table 5-1. I/O Region Register Operations
8-bit byteDigital I/O registersBADR3
N/AN/ABADR2
32-bit double wordPCI I/O-mapped config. registersBADR1
32-bit double wordPCI memory-mapped configuration
registers
BADR0
OperationsFunctionI/O Region
5.1 BADR0
BADR0 is reserved for the PLX-9052 configuration registers. There is no reason to
access this region of I/O space.
5.2 BADR1
BADR1 is a 32 bit register for control and configuration of interrupts.
5.2.1 INTCSR Configure
BADR1 +4C hex
LEVEL/EDGEXINTCLRXISAMDXXX
89101112131432:15
READ/WRITE
INTEINTPOLINTXXXPCINTX
01234567
Note: For applications requiring edge triggered interrupts (LEVEL/EDGE bit 8 = 1),
the user must configure the INTPOL bit for active high polarity (bit 1=1).
The INTCSR (Interrupt Control/Status Register) controls the interrupt features of the
PLX-9052 controller. As with all of the PLX-9052 registers, it is 32-bits in length.
Since the rest of the register have specific control functions, those bits must be
masked off in order to access the specific interrupt control functions listed below.
10