User`s manual

CyberResearch
®
CPU Cards CZGA LX-50
CyberResearch, Inc. 93
25 Business Park Drive P: [phone]; F: [phone]
Branford, CT USA www.cyberresearch.com
Step 4: Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the chassis.Step 0:
5.8.8 TTL LCD Installation
The CZGA LX-50 can be connected to a TFT LCD screen through the 40-pin TTL screen
on the board. To connect a TFT LCD to the CZGA LX-50, please follow the steps below.
Step 1: Locate the connector. The location of the TTL connector is shown in Chapter
3.
Step 2: Insert the cable connector. Insert the connector from the TTL PCB driving
board to the TTL connector as shown in Figure 5-18. When connecting the
connectors make sure the pins are properly aligned.
WARNING:
The diagram below is merely for illustration. The configuration and
connection of the cables from the TFT LCD screen being installed may
be different. Please refer to the installation manual that came with the
TFT LCD screen.