User`s manual

CZGA LX-50 CyberResearch

CPU Cards

5.8.7 USB Cable (Dual Port) with Slot Bracket

The CZGA LX-50 is shipped with a dual port USB 2.0 cable. To connect the USB cable

connector, please follow the steps below.

Step 1: Locate the connectors. The locations of the USB connectors are shown in

Chapter 3.

WARNING:

If the USB pins are not properly aligned, the USB device can burn out.

Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on

each cable connector with pin 1 on the CZGA LX-50 USB connector.

Step 3: Insert the cable connectors. Once the cable connectors are properly aligned

with the USB connectors on the CZGA LX-50, connect the cable connectors to

the onboard connectors. See Figure 5-17.

Figure 5-17: Dual USB Cable Connection