User`s manual

CZGA LX-50 CyberResearch

CPU Cards

Figure 5-14: Single RS-232 Cable Installation

Step 3: Secure the bracket. The single RS-232 connector has one D-sub 9 male

connector secured to a bracket. To secure the bracket to the chassis please

refer to the reference material that came with the chassisStep 0:

5.8.6 SATA Drive Connection

The CZGA LX-50 is shipped with two SATA drive cables and one SATA drive power

cable. To connect the SATA drives to the connectors, please follow the steps below.

Step 1: Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2: Insert the cable connector. Press the clip on the connector at the end of the

SATA cable and insert the cable connector into the onboard SATA drive

connector. See Figure 5-15.