User`s manual

CZGA LX-50 CyberResearch

CPU Cards

Figure 5-10: IDE Cable Connection

Step 3: Connect the cable to an IDE device. Connect the two connectors on the other

side of the cable to one or two IDE devices. Make sure that pin 1 on the cable

corresponds to pin 1 on the connector. Step 0:

5.8.3 Audio Kit Installation

The Audio Kit that came with the CZGA LX-50 connects to the 10-pin audio connector on

the CZGA LX-50. The audio kit consists of three audio jacks. One audio jack, Mic In,

connects to a microphone. The remaining two audio jacks, Line-In and Line-Out, connect

to two speakers. To install the audio kit, please refer to the steps below:

Step 1: Locate the audio connector. The location of the 10-pin audio connector is

shown in Chapter 3.

Step 2: Align pin 1. Align pin 1 on the onboard connector with pin 1 on the audio kit

connector. Pin 1 on the audio kit connector is indicated with a white dot. See

Figure 5-11.