User`s manual

COMHP 7404/-D25 CyberResearch

Serial Communications

Appendix E - Compliance Notices

Federal Communications Commission Statement

FCC - This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in such case the user will be required

to correct the interference at his own expense.

EMC Directive Statement

Products bearing the CE Label fulfill the requirements of the EMC directive (89/336/EEC) and of the

low-voltage directive (73/23/EEC) issued by the European Commission.

To obey these directives, the following European standards must be met:

• EN55022 Class A - “Limits and methods of measurement of radio interference characteristics of information

technology equipment”

• EN55024 -'Information technology equipment Immunity characteristics Limits and methods of measurement'

• EN60950 (IEC950) - “Safety of information technology equipment, including electrical business equipment”

Warning

This is a Class A Product. In a domestic environment this product may cause radio interference in which case the

user may be required to take adequate measures.

Always use cabling provided with this product if possible. If no cable is provided or if an alternate cable is required, use high

quality shielded cabling to maintain compliance with FCC/EMC directives.