Owners manual

CyberPower Remote Management System
12
Recharged Delay
When utility power restores, the UPS will start to recharge until the
specified time has elapsed before restoring output power.
Recharged Capacity
When utility power restores, the UPS will start to recharge until the
specified battery capacity is met before restoring output power.
Returned Delay
The Returned Delay will take effect every time when the UPS is turned
on.
Line Stable Delay
When the UPS is in Battery Mode and utility power is restored, the UPS
will wait for the specific delay time to change Battery Mode to Line
Mode. When the UPS battery is lower than the Low Battery Threshold
and utility power is restored, the UPS will return to Line Mode
immediately.
Battery
Low Battery Threshold
When the UPS supplies battery power and the remaining capacity is
lower than this threshold, the UPS will sound an alarm.
External Battery Modules
Set the amount of external battery modules. This allows for an accurate
runtime estimation based upon the total number of batteries connected
to the UPS.
System
Cold Start
Set the ability of the UPS to start in the absence of input power. When
this option is enabled, the UPS can be turned on with battery power.
Audible Alarm
If this option is enabled, the UPS will issue an audible alarm when
supplying battery power, when output is overloaded, or other conditions
are present (varies by UPS model).
Dry Relay Function
This configures the UPS dry relay to function when the selected
condition occurs. Refer to the UPS manual for further information about
advanced UPS dry relay functions. The Dry Relay Function can be
configured to be activated under the following power conditions:
(1)Utility Failure: The utility power fails and the UPS is using battery
power.
(2)Low Battery: The battery capacity is too low to support the connected
computers to shut down.
(3)Alarm: The UPS is issuing the audible alarm due to the occurrence of
warning events, such as overload.
(4)Bypass: The UPS has switched to Bypass Mode.
(5)UPS Fault: The UPS could be malfunctioning due to hardware fault.
Screen Save Time
When no UPS button is pressed and no power event occurs during this
time, the LCD screen will go to sleep.