Owners manual

CyberPower Remote Management System
6
5. You can modify the IP Address, Subnet Mask, and Gateway address for the Device MAC Address
listed in the Device Network Settings window, as shown in Figure 2. The default IP Address is
192.168.20.177 and the default Subnet Mask is 255.255.255.0.
Figure 2. The Device Network setting window.
6. Modify the IP, subnet mask or gateway address. Enter the new addresses into the corresponding
fields.
7. You will need to enter a User Name and Password for the Remote Management Card in the
authentication window, as shown in Figure 3. There are two combinations of default user name
and password, and both can work.
(1) Default user name: admin
Default password: admin
or
(2) Default user name: cyber
Default password: cyber
Figure 3. Authentication window.