Owners manual

CyberPower Remote Management System
5
Step 2. Configure the IP address for the CyberPower Remote Management Card
Note: These instructions are for Windows OS. For other OS please refer to Appendix 2.
Method 1: Using the Power Device Network Utility tool
1. Install the Power Device Network Utility tool available for download on the Network Power
Management product web page at www.CyberPower.com.
2. After installation completes, run the “Power Device Network Utility”.
3. The main dialog of the Power Device Network Utility Tool program is shown in Figure 1. The
configuration tool will display all CyberPower Remote Management devices present on the same
network subnet. The "Refresh" button is used to search the local network subnet again.
Figure 1. The main window of the “Power Device Network Utility” program.
4. Select the Remote Management Card you are setting up. Click on the Tools menu and select
“Device Setup” or double click the Remote Management Card you want to configure.