Manualshelf

Owners manual

ManualsBrandsCyberpowerPC ManualsBatteries and ChargersCyberPower RMCARD205 UPS and ATS PDU Remote Management Card
12345678910
CyberPower Remote Management System
3
Installation Guide
Step 1. Hardware Installation
Expansion port Remote Management Card
1. Remove the two retaining screws from the expansion port cover and remove the cover.
2. Install the CyberPower Remote Management Card into the expansion port.
3. Re-install and tighten the retaining screws.
4. Connect the Ethernet cable to the Ethernet connector of the CyberPower Remote Management
Card.
5. (Optional) To connect the environmental sensor, use a RJ45 Ethernet cable. Connect one end to
the Universal connector on the RMCARD and the other end into the sensor. For further
information, please refer to the ENVIROSENOR user’s manual.
Note: The CyberPower Remote Management Card is a hot-swap device, so you do not need
to turn off the UPS to install it.
RMCARD305
RMCARD205