Manualshelf

Owners manual

ManualsBrandsCyberpowerPC ManualsBatteries and ChargersCyberPower RMCARD205 UPS and ATS PDU Remote Management Card
21222324252627282930
CyberPower Remote Management System
27
Reset to Default Setting / Recover from a Lost Password
To reset the CyberPower Remote Management Card to its default setting (including WEB log-in user
name and password), please use the following steps:
RMCARD205
RMCARD305
1. Remove the two retaining screws on the card without turning off the UPS.
2. Uninstall the card.
3. Take off the jumper on the Reset pins as illustrated (the jumper is still necessary after reset,
please do not lose or dispose it).
4. Re-install the card into the expansion port.
5. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is one second).
6. Uninstall the card again.
7. Place the jumper back onto the Reset pins.
8. Install card into the expansion port again.
9. Tighten the retaining screws.