Owners manual

CyberPower Remote Management System

Passed: The runtime calibration is completed and the batteries are good.

None: The UPS has never performed a runtime calibration.

Failed: The UPS fails during the runtime calibration.

Canceled: The calibration was interrupted.

• Last Calibration Date: The date of the last Runtime calibration.

Note: 1. It is recommended to perform at least one calibration every 3 months.

2. A complete calibration causes the battery capacity to deplete. Ensure the UPS has

recharged completely after performing a calibration.

[UPS->Schedule]: Sets the UPS to automatically shutdown and restart at scheduled times

(Once/Daily/Weekly). The Schedule page manages scheduled shutdowns and lists all configured

schedules. Each schedule row displays the details of when the schedule will take effect and when to

perform it.

[Once]: The user may set a specific date and time for the UPS shutdown.

[Daily]: Set a specific time of the day for the UPS shutdown.

[Weekly]: Set a specific day and time of the week for the UPS shutdown.

1. Click [Once], [Daily] or [Weekly] option and Click “Next>>”, Enter the date and time to shut down

the UPS. Select [Never], [Instant], or the date and time for the UPS to restore power. Select the

bank to be controlled, and click “Shutdown Clients” to set all clients to perform a graceful

shutdown. You can enter a “Name” for this Schedule.

2. Click “Apply” to add the item to the Schedule. Click “Reset” to remove the item from the Schedule.

3. Applied settings are listed in [Schedule] menu.

Note: The management system allows up to 10 scheduled settings.

[UPS->Wake on Lan] This function is used to wake the PC through the network. Enter the IP

address of that PC when it is on and the system will search its MAC accordingly. The maximum

number of IP that can be set is 50.

Item

Definition

WoL Features

Load/Sync with

PowerPanel

Client List

Load and Sync with PowerPanel Client List. Wake on the PowerPanel

Client network device on power event.

Wake Conditions

UPS Turn On

Enable the option can wake on registered network device when power

event: UPS turned on occur.

Utility Power Restore and

Output is Supplied

Enable the option can wake on registered network device when power

event: UPS Utility Restore and Output is Supplied.

Note: Make sure the PC hardware has such function supported and configures as "Enable"

under BIOS.