Owners manual

CyberPower Remote Management System
13
if the remaining battery capacity is lower than this threshold.
Turn off Delay Time
When supplying battery power, the UPS will power off this NCL outlet
after this delay time is met.
Turn On Delay Time
When the utility power restores, the UPS will restore the output of this
NCL outlet after the delay time is met. This prevents excessive power
consumption caused by all the connected equipment starting at the
same time.
[UPS->Master Switch] Switch the output power of the UPS to be on or off.
Item
Definition
Reboot UPS
Turns the UPS off and back on
Turn UPS Off
Turns the UPS off.
UPS Sleep
This command is available under Utility Power Failure Mode. It can
make UPS in sleep mode until power restore.
Note: Some UPS may not support this command.
Cancel
Cancels a pending action to turn the UPS off.
Turn UPS On
Turns the UPS on.
Shutdown/Sleep Delay
How long the UPS waits before it turns off in response to a "Reboot
UPS", "Turn UPS off" or "UPS Sleep" commands.
Reboot Duration
After the UPS is turned off, Reboot Duration defines how long the UPS
waits before its turned back in response to "Reboot UPS" command.
Signal PowerPanel
®
Clients
to Shutdown
Select this option to warn PowerPanel
®
Business Edition Clients before
UPS turning off. The Shutdown Delay (MST, Max Clients Shutdown
Time) for the UPS can be revised to insure a graceful shutdown.
[UPS->Bank Control] Display the current state of each Bank, and it provides on/off control for the
Non-Critical Outlet Bank. Outlet Index and Device Name display the device name provided power by
the specific outlet.
Item
Definition
Bank Control Options
ON
Turns non-critical bank on immediately.
OFF
Turns non-critical bank off immediately.
Device Name Identification
Outlet #
The index of outlet.
Device Name
Device Name on this outlet.