User Manual

94
Network/Trap Notification page in the UPS RMCARD201 web
Note: SNMP community is limited to 15 characters in the PDU and UPS RMCARD.
Note: If you have firewall software installed, configure the settings to allow access through port 3052 (UDP/TCP), port
53568 (TCP), port 162 (UDP) and port 53566(UDP). The communication between the UPS RMCARD, PDU and
PowerPanel
®
Applications as Agent and Client can only be established when those ports are open.
SNMPv3
The Client uses the below SNMPv3 settings to interact with a secure device. These settings can be configured on the
Security/Authentication page in Client and on the Network Service/SNMPv3 Service page of the UPS
RMCARD/PDU/ATS web. These settings must be matched.
 User Name: Specifies a username match for protocol.
 Authentication Protocol: Sets the protocol to be used for authenticating the network communication between the
Client and devices.
 Authentication Key: Sets the authentication key which is used for the aforementioned authentication protocol.
 Privacy Protocol: Sets the privacy protocol to be used for encrypting data during transmission between the Client
and devices.
 Privacy Key: Sets the privacy key to encrypt data for the aforementioned privacy protocol.
SNMP Agent
PowerPanel
®
Business Edition Agent supports SNMP. Users can use settings to select the NMS (Network
Management Station).