User Manual

76
Trap Receivers
PowerPanel Business Edition Agent supports SNMP traps. Users can set a maximum of 10 receivers to receive trap
messages. Both SNMPv1 and v3 are supported. The listed TRAP receivers will be notified when configured Events
occur.
Trap Receivers settings in Agent
Trap Receivers can be managed as follows:
 Add a new receiver: Click the New Recipient link to open the blank notification recipient fields or use the data
from a selected recipient. Enter all required data and click the Add button to add a new recipient to the list.
 Modify the receiver: Select the recipient you wish to modify from the recipient list. After entering in the new data,
click the Apply button to complete.
 Remove the recipient: Select the recipient to remove from the recipient list, and then click Remove to delete the
recipient selected.
The receiver detail settings and descriptions are explained below:
 Enable: States if the recipient is enabled.
 Name: The name of the recipient.
 lP Address: The IP address of the recipient. If the IP is set as 255.255.255.255, the trap message will be a
broadcast message.
 SNMPv1 Community: The community of SNMPv1.
 SNMPv3 User Name: The user name of SNMPv3.
 Send Test: Sends the trap message in accordance with current settings in order to verify the function.