User Manual

69
3
: This event only occurs in Client.
4
: This %EVENT% variable must come with a %EVENT_CONDITION% variable.
5
: This event only occurs for the ATS in Client.
6
: This event only occurs for the environmental sensor for UPS/PDU/ATS in Client.
7
: This event only occurs for the Metered by Outlet PDU in Client.
Shutdown
Initiate a shutdown sequence when an event occurs. A shutdown sequence is only initiated by events which are of
severe-level and warning-level type.
 Initiated: Determines whether to request that the computer be shut down based on the delay before initiating the
shutdown sequence. The shutdown will be canceled if the event is cleared during this delay time. The minimum
delay time to initiate shut down is based on the time set for the execution of the other actions to complete. This
includes the notify delay time, command delay time and command execution time.
As
This feature is used to apply identical settings to the particular event within the same category (Severe, Warning, and
Information). Once the As field of one event have been assigned, the settings of this event will use the assigned
event’s settings. The settings of this event will match with an assigned event’s.
The setting for the Local communication lost event would be copied from the settings of the UPS is faulty event
Event List
The Event List displays power events. The events displayed vary depending on whether they are listed in Agent or
Client and which UPS/PDU/ATS is providing the events.
Note: If a Client computer has redundant power supplies, the events related to power supply will only be triggered
when power supply redundancy is lost. Please refer to “Remaining runtime will be exhausted” event for example.
 Battery capacity is critically low. Battery capacity is critically low; power could be lost immediately.
 Local communication lost in a power event. Communication with device has been lost during a power event.
Communication between the Agent and the UPS using the USB or serial cable has been lost during a power
failure.
 Batteries are not present. Batteries are not present; the UPS cannot provide battery power in this condition.