User Manual

57
 Current Rating: The output current rating (Amps) of the UPS/PDU/ATS.
 Voltage Rating: The output voltage rating (Volts) of the UPS/PDU/ATS.
 Frequency Rating: The output frequency rating (Hz) of the UPS.
 Battery Replacement Date: The date that the batteries were last replaced.
 NCL Outlet: The amount of NCL (Non-Critical Load) outlets in the UPS.
 Extended Battery Pack: The number of extended battery packs connected to the UPS.
 Name: The name of the UPS/PDU/ATS.
 Location: Where the UPS/PDU/ATS is located.
 Contact: Who to contact about the UPS/PDU/ATS.
 MAC Address: The MAC address of the UPS RMCARD, PDU or Agent’s network interface.
 IP Address: The IP address of the UPS RMCARD, PDU or Agent’s network interface. Click the hyperlink to open
the web interface of the UPS RMCARD, PDU or Agent.
 UPS on Source A: Indicates which UPS connects to input source A of ATS.
 UPS on Source B: Indicates which UPS connects to input source B of ATS.
 Environment Sensor: Indicates whether the environment sensor has been installed on the UPS/PDU/ATS.
Note: When the sensor cannot be detected anymore, it will be annotated No Response. Users must click the
Uninstall option if the sensor has been physically removed from the UPS/PDU/ATS.
Note: Not all models provide the same information. The information displayed will vary by model.
Configuration
In order for computers which have the PowerPanel Business Edition Client software installed to be aware of the UPS
state and get shutdown protection from power events, the correct connection type, address and connected outlet must
be assigned properly in the Power/Configuration page.
Note: If the Client computer has redundant power supplies, please make sure that configuration of all the power
supplies must be assigned properly.