User Manual

53
 Move PDU/ATS’s plug to another UPS outlet. Select the target PDU/ATS tab you want to move. Select
Configure PDU/ATS from the drop-down menu by clicking the Power Distribution shortcut on the list and select
another UPS outlet on UPS outlet option. Click Apply to complete.
 Uninstall the PDU/ATS from UPS. Select the target PDU/ATS tab you want to uninstall. Select Configure
PDU/ATS from the dropdown menu by clicking the Power Distribution shortcut on the list. Select Disconnect
PDU/ATS with UPS option and click Apply to complete.
Note: When a PDU/ATS is uninstalled from the UPS, all loads include generic equipment and computers on this
PDU/ATS will be removed; computers will also no longer retain communication with the UPS.
Note. PDU or ATS may be configured in the Power/Configuration page of PPBE Client’s web interface. A named
PDU/ATS tab with the tip “Does PDU/ATS connect to UPS?” will appear automatically for users to confirm it.
Note. PPBE does not allow ATS to connect two input sources to one single UPS.
Client computer is printed in gray when the communication is not established
The details in list are described as following:
 #: Indicates which power outlet of the UPS or PDU is supplying power to the connected equipment.
 Bank: The bank type of the power outlet on the UPS, e.g. NCL, CL or Surge.
 Name: The name of the power equipment.
 Location: Where the power equipment is located.
 Contact: Who to contact about this power equipment.
 IP Address: The IP address of the computer that installed PowerPanel Business edition Client software. In UPS
tab, a PDU with network function also shows its own IP address.