User Manual

148
In order to search devices and computers in different segments or a specific range, users can set IP range on this
page. The settings will be used on the Management/Power Equipment page.
IP ranges can be managed as follows:
 Add a new IP range: Click the New Range to have the blank IP range fields or use the data from a selected IP
range. Enter all required data and click the Add button to add a new IP range to the list.
 Modify the IP range: Select the IP range you wish to modify. After entering in the new data, click the Apply
button to complete.
 Remove the IP range: Select the IP range to remove from the IP range list, and then click Remove to complete
the IP range deletion.
The IP range detail settings and descriptions are explained below:
 Scan Mode: If any IP range is active in the list, the scan mode will be changed to Custom, the scanning will scan
a specific range which configured in IP range field. Otherwise, the scan mode is Local Subnet, the scanning will
scan devices and computers in the same segment.
 Active: States if the IP range is active.
 IP Range: Set the range which used in devices and computers scanning.
 Comment: Sets the user-defined comments for this IP range.
Help
Content
Please refer to Help/Content section about further details.
About
Please refer to Help/About section about further details.
Logout
The Logout page allows users to log the user out of the web interface. The user will be asked to assure whether to
log out, and users can log out web by clicking the Logout button.
Technical Support
Troubleshooting
1. I cannot access the PowerPanel
®
Business Edition web interface after complete installation.
Please follow the below steps resolve the problem: