User Manual

142
 Shutdown initiated. A computer which connects with UPS initiated the shutdown process. The computer will shut
down or enter hibernation.
 Battery has fully charged. Battery has fully charged. The capacity of battery is full.
 Battery capacity is critically low. Battery capacity is critically low; power could be lost immediately.
 An outlet on a UPS has turned on. A UPS outlet has been turned on. The outlet can afford the power to its
connected equipment.
PDU
 Network communication lost. Center cannot establish communication with PDU on the network or established
network communication has been interrupted.
 Input is near overload. A PDU is near an overload condition. The load level is near the safe load threshold for
the PDU.
 Input is overloaded A PDU is in an overload condition. The safe load threshold has been exceeded.
 Power consumption is too high. Power the specific PDU consumes has been exceeded the high threshold.
 Power consumption is too low. Power the specific PDU consumes has been violated the low threshold.
 Shutdown initiated. A computer connected to the UPS has initiated the shutdown process. The computer will
shut down or enter hibernation soon.
 A PDU outlet is overloaded. An outlet of Metered by Outlet PDU is in an overload condition. The safe load
threshold has been exceeded.
 A PDU outlet is near overload. An outlet of Metered by Outlet PDU is near an overload condition. The load level
is near the safe load threshold for the outlet.
ATS
 Network communication lost. Center cannot establish communication with a ATS on the network or established
network communication has been interrupted.
 ATS is faulty. ATS has an internal malfunction and may not operate properly.
 Both input sources have power loss, ATS will not change input source. ATS will not switch from one input
source to another because both are experiencing power failures.
 Input is near overload. An ATS is near an overload condition. The load level is near the safe max load threshold
for the ATS.
 Input is overloaded. An ATS is in an overload condition. The safe max load threshold for the ATS has been
exceeded.
 Power consumption is too high. ATS power consumption has gone above the high threshold.
 Power consumption is too low. ATS power consumption has gone below the low threshold.
 Shutdown initiated. A computer connected to the ATS has initiated the shutdown process. The computer will
shut down or enter hibernation soon.
Notification Recipient
Please refer to Event Action/Recipient section about how to define notifications,
Settings