User Manual

111
ATS have the following states on functioning:
ATS uses this input source as current source, and this source is normal.
ATS uses this input source as redundant source, but this source is normal.
ATS uses this input source as current source, and this source is power
failure.
ATS uses this input source as redundant source, but this source is power
failure.
The sensor on the UPS/PDU/ATS has the following states according to the environment temperature:
Normal. Indicates the temperature measured by the sensor is in a predefined
normal range.
Overheated. Indicates the current temperature exceeds the high temperature
threshold.
Undercooled. Indicates the current temperature violates the low temperature
threshold.
The sensor on the UPS/PDU/ATS has the following states according to the relative humidity:
Normal. Indicates the humidity as a percentage measured by the sensor is in
a predefined normal range.
Over wet. Indicates the current humidity exceeds the high humidity
threshold.
Overdried. Indicates the current humidity violates the low humidity threshold.
A group has the following states according to the total power consumption:
Indicates the total power consumption of the group falls in the normal range.
Indicates the total power consumption of the group exceeds the high
threshold.
Indicates the total power consumption of the group violates the low threshold.
Device Management
Add Device
In order to monitor and control UPS/PDU/ATS it first must be added to the Center by clicking Add Device button on
the toolbar.
Add Device button on toolbar