User`s manual

9
Copyright © 20
12
CyberPower Systems, Inc.
OFF
ON
BATTERY
PACK
INPUT:
48V
(Change Only)
AC INPUTAC OUTPUT
RESET
Push To
48V
OUTPUT:
Step 3: Connect the Battery Pack to wall power
Plug the female end AC Power Cord into the Battery Pack, and plug the male end into a
wall receptacle or PDU. Note: Do NOT plug this AC Power Cord into a UPS.
If using multiple Battery Packs, use the Auxiliary AC Power Cord to provide power to
subsequent power to additional Battery Packs.
Step 4: Turn the Battery Pack power switch ON
Step 5: Turn on your UPS system
Plug your UPS system into the wall receptacle, and safely power-up your UPS system
and connected equipment.
Battery Pack Configuration
In order for the UPS to recognize the addition of the Battery Pack(s), you must configure
the UPS to recognize the presence of the additional battery packs.
Step 1: Access the Utility menu on the UPS.
Press the Select button once to activate the Multi-function LCD Readout. Then, press
and hold the Select button for 10 seconds to access the Utility menu. Note: the UPS will
start beeping during this process.
Position the On/Off switch on
the back of the Battery Pack to
the “On” position.