User`s manual

CyberPower Network Management System

INSTALLATION GUIDE

Step 1. Hardware Installation

a. Internal smart slot network management card

1. Turn off the UPS before removing the expansion port cover on the UPS..

2. Connect the internal data and power connector inside the expansion port to the

CyberPower Network Management Card.

3. Slide the CyberPower Network Management into the expansion port, and cover with

screws.

4. Connect the Ethernet cable to the LAN port of the CyberPower Network Management Card.

5. After the above procedures are complete, turn on the UPS and press the Reset Button on

the Network Management Card for 7 seconds to ensure the IP Address is set to the default

value.

a. External network management card

1. Connect the Ethernet cable to the LAN port of the CyberPower Network Management Card.

2. Connect the CyberPower Network Management Card to the UPS communication port. It

is optional to use the included serial cable.

3. Connect the supplied AC/DC transformer to the Network Management Card Adapter and

plug into the wall socket. (For select UPS models only).

4. After the above procedures are complete, press the Reset Button on the Network

Management Card for 7 seconds to ensure the IP Address is set to the default value.