User`s manual

CyberPower Network Management System
3
Description
a. Internal smart slot type
2
5
3 4
1
1) Signal connector provides a connection for communication between the UPS and the
Network Management Card
2) Reset Button is used to reset the card to default settings. When the Reset Button is pushed
for 3 seconds, all settings will reset to default values except for the IP address for Network
Management Card. When the Reset Button is pushed for more than 3 seconds, all settings
including the IP address for CyberPower Network Management Card will reset to default
values.
3) MSG Indicator indicates the status of connection between UPS and the Network
Management Card. This indicator light will flash when Network Management Card IS NOT
connected to the UPS.
4) LINK Indicator indicates the status of network connection. It illuminates when the Network
Management Card is connected to the network.
5) 10M Ethernet connector
Definitions for LED Indicators
Indicator Mode Condition
Off The Network Management Card is connected to UPS
MSG
(Red)
Flashing No connection between the Network Management Card and
the UPS
Off The Network Management Card is not connected to the
Network
LINK
(Yellow)
On The Network Management Card is connected to the Network