User`s manual

CyberPower Network Management System

1. Input the receiver IP address. This address will identify the receiver of traps. The default

value 0.0.0.0 or 255.255.255.255 which defines all NMS as receivers.

2. Input the community (functions as the password, maximum of 15 characters).

3. Select one option [Enable] or [Disable].

4. Click [Apply] to activate the settings, click [Cancel] to revert to the previous settings.

Enable The trap will be generated.

Disable The trap will not be generated.

[Events] displays an event log for the UPS. The section contains [Event Log] page [Event

Generation] page and [UPS Shutdown] page.

[Event Log] displays the Network Management Card events by date and time. More than 200

events can be displayed.

Red：Severe

Brown：Warning

Black：Information

[Event Generation]: There are three severity levels, Information, Warning, and Severe.

Please refer to their definitions below. The User can assign which severity levels will be recorded

in the event log and which severity levels will cause SNMP traps to be sent.