User`s manual

CyberPower Network Management System
12
[UPS Reboot] allows advanced remote control of the UPS. Select one function by clicking its
button. Click [Apply] to begin the operation. Select [Cancel] to refresh the selection.
Note: The commands in [UPS Reboot] menu may be changed with the settings in the [UPS
Schedule] menu.
Commands Definition
Reboot UPS Immediately To turn the UPS off and then on again.
Delay 03 min(s) to Reboot
UPS
3 minutes is a default value. The user may select any
number between 1 and 99. The UPS will shut off and
wait the set amount of time before turning back on.
Cancel Reboot UPS
To stop the previous command “Delay 03 min(s) to
Reboot UPS.
Turn Off UPS Immediately To turn the UPS off immediately.
Delay 03 min(s) to Turn Off
UPS
3 minutes is a default value. The user may select any
number between 1 and 99. The UPS will wait the set
amount of time before turning OFF.
Cancel Turn Off UPS
To stop the previous command “Delay 03 min(s) to
Turn Off UPS
Turn On UPS Immediately To turn on UPS when it is turned off.