User`s manual

CyberPower Network Management System
11
[Control] menu contains [UPS Control] page, [UPS Reboot] page, and [UPS Schedule] page.
[UPS Control] allows basic remote management of the UPS.
Select one test by clicking the button on the left of the command. Click [Apply] to run the test.
Click [Cancel] to stop any command that has been selected.
Please Note: If the UPS is shut OFF, the following commands will not work. The Network
Management Card will display the message: “Command fails. UPS is turned off.”
Commands Definition
Auto Diagnostics
To verify that the UPS can function correctly in battery
mode.
Deep Battery Test
The Deep Battery Test will discharge the batteries.
The test will automatically stop when the batteries are
low, and return to AC-On line power.
Cancel Deep Battery Test This command will stop the Deep Battery Test.
Put UPS to Sleep Mode To turn off the UPS (no power output from the outlets).
Wake up UPS To turn on the UPS when it is in sleep mode.
Turn Off UPS Buzzer To turn the audible alarm of the UPS on/off.