User`s manual

CyberPower Network Management System

Method 2 : Using a command prompt

1. Obtain the MAC address on the label of the Network Management Card rear panel. Each

Management Card has a unique MAC address.

2. Use the ARP command to set the IP address. For example, to assign an IP address

192.168.20.240, in the same subnet as your computer, for the Network Management Card,

which has the MAC address 00-0c-15-00-00-01, type:

arp –s 192.168.20.240 00-0c-15-00-00-01

and press Enter.

3.To verify the setting, please type:

ping 192.168.20.240

and press Enter. If replies are received, your computer can communicate with the IP

address.

To find an IP address for the Network Management Card, please refer to Appendix 2.

If you want to assign an IP address, which is in a different subnet than your computer, for the

Network Management Card, you should followed Step 2, and then use the Browser Mode

Configuration to configure the IP address.

1. Open a Web Browser (Internet Explorer or Firefox)

2. Enter the IP Address which you previously configured.

3. On the login page enter the default username “cyber” and password “cyber”.

4. Click on TCP/IP Configuration on the Network menu to change the IP address. Click

‘Apply’ to save.