CP1350EAVRLCD/CP1500EAVRLCD User’s Manual K01-0000076-00
IMPORTANT SAFETY INSTRUCTIONS This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or operate. CAUTION! The UPS must be connected to a grounded AC power outlet with fuse or circuit breaker protection. DO NOT plug the UPS into an outlet that is not grounded.
/900W for CP1500EAVRLCD). If the rated unit capacities are exceeded, an overload condition may occur and cause the UPS unit to shut down and the circuit breaker to trip. 3.If the power requirements of your equipment are listed in units other than Volt-Amps (VA), convert Watts (W) or Amps (A) into VA by performing the calculations below. Note: The equation listed below only calculates the maximum amount of VA that the equipment can use, not what is typically used by the equipment at given time.
Hardware Installation Guide 1. Your new UPS may be used immediately upon receipt. However, recharging the battery for at least 8 hours is recommended to ensure that the battery's maximum charge capacity is achieved. Charge loss may occur during shipping and storage. To recharge the battery, simply leave the unit plugged into an AC outlet. The unit will charge in both the on and off position. 2. If you will use the software, connect the USB cable to the USB port on the UPS. 3.
same. On average utility power operates 88% of the time and the CyberPower GreenPower Technology will work in its money/energy saving Bypass Mode. BATTERY REPLACMENT CAUTION! Read and follow the IMPORTANT SAFETY INSTRUCTIONS before servicing the battery. Service the battery under the supervision of personnel knowledgeable of batteries and their precautions. CAUTION! Use only the specified type of battery. See your dealer for replacement batteries.
DEFINITIONS FOR ILLUMINATED LCD INDICATORS INPUT voltage meter: This meter measures the AC voltage that the UPS system is receiving from the utility wall outlet. The UPS is designed, through the use of automatic voltage regulation, to continuously supply connected equipment with stable, 220/230 output voltage. In the event of a complete power loss, severe brownout, or over-voltage, the UPS relies on its internal battery to supply consistent 220/230 output voltage.
TECHNICAL SPECIFICATIONS Model Capacity (VA) Input Input Voltage Range Frequency Range AVR Function Output On Battery Output Voltage On Battery Output Frequency Transfer Time Overload Protection Surge Protection Lightning / Surge Protection Network/ Phone/ Fax/ Modem Protection Operating Temperature Physical Total # of UPS outlets Maximum Dimensions(LxWxH) Weight (kg) Battery Sealed Maintenance Free Lead Acid Battery Typical Recharge Time Charging Current(Max.
TROUBLESHOOTING Problem Full-time surge protection outlets stop providing power to equipment. Circuit breaker button is projecting from the side of the unit. Possible Cause Turn the UPS off and unplug at least one piece of equipment. Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. Circuit breaker has tripped due to an overload. Battery not fully charged. The UPS does not perform expected runtime. The UPS will not turn on. Battery is slightly worn out.
