User’s Manual for: UP625 UPS UP825 UPS ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT: www.cyberpowersystems.com/FAQs.
TABLE OF CONTENTS IMPORTANT SAFETY WARNINGS…………….………………………………………………1 INSTALLING YOUR UPS SYSTEM…………………….………………………………………2 - UNPACKING…… ……………………………………………………………….2 - HARDWARE INSTALLATION GUIDE…………………………………………2 BASIC OPERATION………………………………………….................................................2 - FRONT PANEL AND REAR PANEL DESCRIPTION..................................2 BATTERY REPLACEMENT AND STORAGE…………………………………………….….4 - BATTERY REPLACEMENT PROCEDURE……………......................
UP625/ UP825 Guaranteed Uninterruptible Power System IMPORTANT SAFETY WARNINGS (SAVE THESE INSTRUCTIONS) This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or operate. CAUTION! The UPS must be connected to an AC power outlet with fuse or circuit breaker protection.
INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (1) UPS Unit; (1) PowerPanel Plus Software Disk; (1) Serial Interface Cable (DB-9); (1) Telephone Cable; (1) User’s Manual; (1) Warranty Registration Card HARDWARE INSTALLATION GUIDE 1. Connect the equipments to your UPS outlets. Items such as copiers, laser printers, vacuums, space heaters, or other large electrical devices should not be connected to the UPS.
UP625/ UP825 Guaranteed Uninterruptible Power System ◆ Power Button Press the power button to turn the UPS ON or OFF ◆ Power On Indicator This LED is illuminated when the utility condition is normal and the UPS outlets are providing “clean power”, free of surges and spikes. ◆ Using Battery Indicator This illuminates during utility failure, indicating that the battery is supplying power to the battery-power supplied outlets.
BATTERY REPLACEMENT AND STORAGE Contact your dealer or call the number in this manual for information on battery replacement. The order numbers for the battery are as follows: BA-UP625 for UP625 BA-UP825 for UP825 CAUTION! Read and follow the IMPORTANT SAFETY INSTRUCTIONS before servicing the battery. Service the battery under the supervision of personnel knowledgeable of batteries and their precautions. Keep unauthorized personnel away from batteries. CAUTION! Use only the specified type of battery.
UP625/ UP825 Guaranteed Uninterruptible Power System 5. Remove the battery from the compartment. 6. Disconnect the battery wires from the battery. 7. Install the replacement battery by connecting the red wire to the positive (+) terminal of the battery and connecting the black wire to the negative (-) terminal of the battery. 8. Slide the battery back into the compartment. 9. Replace the cover and the 4 retaining screws. 10. Recharge the unit for 4 – 8 hours to ensure the UPS performs expected runtime.
TROUBLESHOOTING Problem The UPS does not perform expected runtime. The UPS will not turn on. Outlets do not provide power to equipment Possible Cause Solution Batteries are not fully charged. Recharge the battery by leaving the UPS plugged in. Battery’s capacity diminishes over time and use. The on/off switch is designed to prevent damage by rapidly turning it off and on. Contact CyberPower Systems at tech@cyberpowersystems.com The unit is not connected to an AC outlet.
UP625/ UP825 Guaranteed Uninterruptible Power System TECHNICAL SPECIFICATIONS Model Capacity (VA) Capacity (Watts) Input Input Voltage Range Frequency Range Output On Battery Output Voltage On Battery Output Frequency Transfer Time (Typical) Overload Protection Surge Protection and Filtering Lightning / Surge Protection Internet Ready (DSL / Phone / FAX / Modem Protection) Physical Total # of UPS Receptacles Maximum Dimensions Weight Battery Sealed Maintenance Free Lead Acid Battery User Replaceable Typica
DEFINITIONS FOR ILLUMINATED LED INDICATORS Condition Power On Wiring Fault Using Battery On Off Off Circuit Breaker Alarm Set Off Normal Utility Failure- The UPS is providing battery power to the Battery-Power Supplied outlets. Off On/Off On Set Two Beeps Off On/Off On Set Rapid Beeps Utility Failure- The UPS is providing battery power. The rapid beeps indicate the battery will run out of charge within a few minutes.
UP625/ UP825 Guaranteed Uninterruptible Power System below. Additionally, State or Provincial law may adjust the terms of the Limited Warranty or the Power Control Guarantee or the State or Province may impose additional obligations, or additional "implied warranties." To the extent necessary to comply with those laws, the terms of the Limited Warranty and the Power Control Guarantee should be read to adjust to those requirements only to the extent necessary to comply with such local law.
9 CyberPower will inspect and examine the Product within ten (10) days of receipt. If the Product is not as warranted, CyberPower will repair or replace the Product and return it to you at CyberPower's expense, or, if CyberPower is unable to or decides not to repair or replace the Product (if defective) within a reasonable time, CyberPower will refund to you the full purchase price you paid for the Product (purchase receipt showing price paid is required).
UP625/ UP825 Guaranteed Uninterruptible Power System end-user consumer purchaser of the product. 2. Call CyberPower at (952) 403-9500, write to CyberPower at 5555 12th Ave East, Suite 110, Shakopee, MN 55379, or e-mail CyberPower at tech@cyberpowersystems.com within ten (10) days of the date of the event for which you wish to make a claim for warranty service. 3. When you contact CyberPower, identify the Product, the Purchase Date, and the item(s) of Connected Equipment.
11 Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to the period of ownership by the Initial Customer. This provision shall NOT create any Implied Warranty or Merchantability or of Fitness for a Particular Purpose that would not otherwise apply to the Product. NOTE: Some States do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
UP625/ UP825 Guaranteed Uninterruptible Power System 12 Exclusion of Consequential and Other Damages. The sole and exclusive remedies of the Initial Customer are those provided by the Limited Warranty and Power Control Guarantee. CyberPower excludes any liability for personal injury under the Limited Warranty and Power Control Guarantee.
13
