CyberPower Network Management System Rev.1.2 www.cyberpowersystems.
CyberPower Network Management System INSTALLATION GUIDE Step 1. Hardware and Tool Installations 1. Connect the Ethernet cable to the LAN port of the CyberPower Network Management Card. 2. Connect the CyberPower Network Management Card to the UPS communication port (serial port). The included serial cable may be used if needed. 3. Connect the supplied AC adapter (for select UPS models only) to the Network Management Card Adapter and plug into the wall socket. 4.
CyberPower Network Management System In this section, it will be introducing the “SNMP Card Configuration Tool” program. If a DHCP network service is not available or you want to assign a new IP Address to the SNMP card, please follow the steps listed below: I. IP setup using “SNMP Card Configuration Tool” program: 1. Please run the “wsnmpcfg” program in the “All Programs”->“SNMP Card Configuration Tool”. 2. The main dialog of the “SNMP Card Configuration Tool” program is shown as Figure. 2.
CyberPower Network Management System 6. First, choose either IP or MAC address from device address option. 7. Then click on each checkbox to modify new IP, new subnet mask or new gateway address from modify option. Last, input the new address on the right for the chosen checkbox. 8. You need to input password of the SNMP card (Note 3) in the authentication dialog, as shown in figure 4. Figure 4. Authentication dialog. 9.
CyberPower Network Management System Figure 6. Web Browser. Note: 1. If your computer has installed firewall software that software may pop up the Windows Security Alert message shown as Figure 7. You need to unblock the“ wsnmpcfg.exe” program before you run the program. Figure 7. Windows Security Alert. 2. Please refer to the SNMP card hardware manual to obtain the correctly user name and password if you forget user name or password.
CyberPower Network Management System When the “SNMP Card Configuration Tool” program is unable to use, it can use the Command Line tool instead of the “SNMP Card Configuration Tool” program to setup IP. Please follow the steps listed below: II. IP setup using Command Line command: 1.Obtain the MAC address on the label of the Network Management Card. (Each Network Management Card has a unique MAC address). 2.To assign an IP address of 192.168.20.
CyberPower Network Management System Appendix 1 IP Address Settings of CyberPower Network Management Card Overview All devices on a computer network need to have an IP address. Each device’s IP address is must be unique. In order to assign an IP address to the CyberPower Network Management Card you must determine your network configuration. PLEASE NOTE: You may need to contact your network administrator. Procedures to find an IP address: 1. Locate the subnet of CyberPower Network Management Card.
CyberPower Network Management System If the response is shown as below, the IP address is already in use by other equipment. Try another IP address until an available address is found.
