Integration Guide

“This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
If the final product is to be sold in Canada, then this exterior label should use wording
such as the following: “Contains Transmitter Module IC: 11470A-CPWM
U01”
USER MANUAL
The following statements should be inside the user manual of the final products that contains
this module:
Changes or modifica�ons not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Canada:
L’émetteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre
le fonctionnement.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1) this device may not cause interference,
2) this device must accept any interference, including interference that may cause
undesired operation of the device.
The antenna of this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitters within a host device, except in accordance with FCC multitransmitter
product approval procedures. Only external antenna (Max. gain of dipole antenna is 2.74dBi) as
AN2400-39A14BBF can be used for this module, and the printed antenna is not used.