User's Guide

Appendix B. PanelSense APS-FPD
B.6
To install the SENA link:
1. Connect the SENA Link module to a high power USB port directly to your PC
2. Windows will recognize the SENA Link module and the “Found New Hardware” wizard
will appear. Select “Install the software automatically (Recommended)”, if prompted.
Note: Use Windows generic Bluetooth Radio Driver only. Other Drives (BlueSoleil,
etc.) may not be compatible with ParticleSpectrum.
Pairing APS-FPD to the SENA Link in
ParticleSpectrum
To complete the installation, verify that the APS-FPD and SENA Link can communicate and
connect/pair.
1. Run the ParticleSpectrum application by navigating to Start Menu > Programs >
CyberOptics > ParticleSpectrum
2. To connect/pair the APS-FPD, ensure the device is turned on. Locate the “C” button on
the unit and press with a key to initiate pairing mode.
Figure B.5: APS-FPD Pairing