User's Guide

i
General
Information
Note: This manual is for Airborne Particle Sensor technology products including
WaferSense APS3 and PanelSense APS-FPD. The devices may also be referred to as
WaferSense APS in the software section but is applicable to all form factors using APS3
technology.
WaferSense and PanelSense Device and Link
Changes or modifications not expressly approved by CyberOptics Corporation, may void your
authority to operate the APS device.
The radio contained in the APS meets all the applicable FCC requirements for RF Safety. While
in operation, the FCC requires users and nearby persons to maintain a minimum separation
distance of 20 cm (8 inches) or farther from the APS3.
The APS3 Device and Link have been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
Software Note: ParticleSpectrum files are not backwards-compatible with previous
versions of ParticleView and ParticleReview. Files that were recorded from ParticleView
and ParticleReview will not be compatible with ParticleSpectrum.