User's Guide

Chapter 3. Using Your APS3
3.9
To set the Go/No-Go threshold:
1. Click Configure Go/No-Go (see Figure 3.6).
Figure 3.6: Setting the Go/No-Go Thresholds
The Set Go/No-Go Threshold dialog is displayed, as shown in Figure 3.7.
Figure 3.7: Set Go/No-Go Threshold Dialog
2. Under Threshold Type, select either a Frequency Threshold alarm or a Density
Threshold alarm. To disable the alarm, select None. Note that choosing a threshold type in
the Set Go/No-Go Threshold dialog doesn’t affect whether the measurements
Configure
Go/No-Go
Threshold
type
Threshold
Settings