User's Guide
Chapter 2. Installing Your APS3
2.7
Registering Your APS for Calibration Service
To maintain optimum performance, every twelve months you should have your APS
calibrated and the battery replaced. These services can be performed only at the factory.
To help you keep track of the next service date so you can schedule this service when it is
convenient, register your APS device with the factory. When you start the ParticleSpectrum
application (see “Running the ParticleSpectrum Application,” on page 2.8), it prompts you to
register your APS3 device for calibration. You can also register your APS device in any of the
following ways:
• On the Internet: http://cyberoptics.com/semiconductor/wafersense-reticlesense-
registration/
• By sending an e-mail message containing the model, serial number, and contact
information to wsregister@cyberoptics.com
Large Particle Detection: APS3 units are capable of measuring large particles. This is in addition
to the normal small particle detection. Large particle operation is very similar to small particle
detection so that all of the sections in this manual describing settings and operation are still valid for
large particle detection. How to operate large particle detection and the differences between the two
modes are described in Appendix A – Large Particle Detection.