User guide

R
e
vi
e
w
e
r
Gu
i
de
Authentication Select the checkbox if you want to enable authentication for your
USB modem.
Username Specify the username if you have enabled authentication for your
USB modem.
Password Specify password.
Pincode Specify the pin code of your area.
Init String Specify initialization string for your USB modem, if required.
Connection on
Demand
Select the checkbox against ‘Disconnect in’ and specify the value
in seconds. Connection will drop after the configured inactivity
time and user will be forced to re-login.
MTU Specify MTU value (Maximum Transmission Unit)
MTU is the largest physical packet size, in bytes that can be
transmitted in a network. This parameter becomes an issue when
networks are interconnected and the networks have different MTU
sizes. Any packets larger than the MTU value are divided
(fragmented) into smaller packets before being sent over.
Default - 1492
Input range - 568 to 1492
DNS Server Configuration
Static DNS Server Select the checkbox to configure static DNS server.
Primary Specify IP address of the primary DNS server.
Secondary Specify IP address of the secondary DNS server.
MAC Address
Clone
Enable this to create a clone of your router’s IP address.
MAC Address Specify MAC address of your router that has to be cloned.
Table- Configure USB Modem Screen Elements
Configuring Static Internet Connection
You need to configure static Internet connection if your ISP has assigned an IP address to your
network.
Go to Network Settings → Internet. Select the Internet connection type as “Static” and fill
up the required details.
16