Operation Manual

236
CyberLink PowerDirector
Configuring Burn Settings
Before you burn to a disc for the first time, it is advised that you click on to
set your burning configuration as follows:
Recording drive: select the burning drive (or removable disc for the AVCHD
format) CyberLink PowerDirector will use to burn the production to disc.
Recording speed: set the recording speed used when burning the disc. If you
encounter errors during the burning process, try lowering the burning speed.
Include buffer under-run protection: select this option to ensure that video is
written to disc without interruption. An interruption in video burning can
result in an unusable disc.
After you set this configuration, CyberLink PowerDirector uses the same
configuration each time you burn until you change the settings.
Erasing Discs
If you are using a rewritable disc, you can erase content that has data previously
recorded on it. This allows you to reuse the same discs over and over without the
need to continually buy new discs. Click on the button to begin erasing a
disc.
To erase a disc, select:
the Quick option to erase the disc index contained on the disc.
the Full option to erase all of the content the disc contains.
Click OK to erase the disc.