Operation Manual

179
PowerDirector Preferences
at the same time. Without a buffer, batch capturing or writing to tape may
begin before the camcorder is engaged. In the DV auto stop section of the DV
Parameters Setup window, select whether you want CyberLink PowerDirector
to automatically stop scanning/capturing after a specified interval of blank
tape. You can specific the interval, in seconds, in the field provided.
Confirmation Preferences
In the Preferences window, select the Confirmation tab. The available options are as
follows:
Confirmation
Always prompt me when TV format conflicts: select this option to enable a
warning message when you add a video clip to the workspace whose TV
format (NTSC/PAL) conflicts with that of the video clips already located in the
editing workspace.
Always prompt me when aspect ratio conflicts: select this option to enable a
warning message when you add a video clip to the workspace whose aspect
conflicts with that of the project.
Enable file deletion from hard drive: select this option if you would like to
enable the deletion of files from your hard drive when in the media library.
Enable warning when chapters are removed during editing: select this option
to enable a warning message if chapter points are deleted during video
editing.
Always prompt me when widescreen is not supported: select this option if
you want PowerDirector to notify you when a widescreen format is not
supported.
Always prompt me when I import high definition video into the library: select
this option if you want PowerDirector to notify you when you are importing
high definition video into the media library.
Always prompt me to confirm captured video prefix name: select this option
if you want PowerDirector to ask you for a file name when capturing videos in
the capture window. If you deselect this option, PowerDirector will auto name
the files for you.
Always prompt me to confirm captured snapshot file name: select this option
if you want PowerDirector to ask you for a file name when capturing screen