Operation Manual

46
CyberLink Power2Go
process:
select Perform write simulation if you want CyberLink Power2Go to simulate
the burning process first to ensure the burn will finish successfully.
select Verify recorded data if you want CyberLink Power2Go to verify that the
content was successfully burned to the disc.
select Enable defect management to have CyberLink Power2Go try to fix any
defects on a disc so that content burns correctly.
7. Click Burn to start the burning process.
Note: select the Auto shut down after burning option if you want CyberLink
Power2Go to automatically shut down your computer once it has successfully
burned your disc.
8. When burning is complete, select an option in the window that opens:
Click the View Log link to view the burning log. The log opens in your default
TXT editor, where you can view and save it.
Click Print Label to create a disc label for the disc in CyberLink LabelPrint, if it
is installed on your computer.
Click Capture Label to take a photo snapshot that will be used to help identify
the burned disc it in the Disc Manager*.
Note: if you chose to print a disc label in CyberLink LabelPrint, you don't need to
capture the label as CyberLink Power2Go automatically imports the created label
into the Disc Manager. See Disc Label Snapshots for information on viewing and
editing the label snapshot.
Click OK to close the window.
Note: * this feature is not available in some versions of CyberLink Power2Go.