Operation Manual

Copy Disc

Chapter 9:

The Copy Disc function allows you to make an exact copy of a disc. However, you

must copy the disc contents onto a blank disc of the same disc type. You cannot,

for example, copy content from a CD onto a DVD. The Copy Disc function also

allows you to save or burn disc images.

Note: some discs may not be copied if they are copy-protected or contain errors.

Copying Discs

With CyberLink Power2Go you can copy and burn the entire contents of a disc

onto another disc. You can perform this function in both Power2Go Full Program

mode and using the Desktop Burning Gadget. Only the first step for opening the

Copy Disc window is slightly different.

To copy a disc, do this:

1. Open the Copy Disc window by:

selecting the Copy Disc option, and then Copy Disc in the new task window

when in Power2Go Full Program mode.

selecting the button on the Desktop Burning Gadget until the Copy Disc

gadget displays, and then clicking on to open the Copy Disc window.

2. Select your source and target drives using the From and To drop-downs.

3. Select a Read speed and Write speed for each disc. The speeds you should

select will depend on the burning drives you are using and the quality of the

discs.

4. Select Ignore reading error if you want CyberLink Power2Go to copy the disc

even if errors are encountered.

5. Select the Copy to hard disk option, if available, to also save a copy of the disc

to your computer’s hard drive.

6. Select Copy whole disc if you want to copy the entire contents of the disc

onto the destination disc.

7. Enter the Number of copies you want to burn.