Operation Manual

CyberLink Power2Go

Video and Audio Settings

Select the video recording format: if available for your selected disc format,

select the recording format of the video on your disc and its aspect ratio.

Select the video encoding format and quality: if available for your selected

disc format, select an encoding format and video quality for your disc. The

Smart Fit option automatically adjusts the bit rate to the best quality video

file that fits exactly to the capacity of the disc you are using.

Select the audio encoding format and channels: select an audio format for

your disc, and the number of channels it is capable of outputting to.

Note: the video quality and audio type options that are available depend on the

disc format that you have selected.

TV Format: select the TV format (NTSC or PAL) for your video. This format

should correspond to the region in which you plan to play your video disc.

Burning Video to Disc

Burning the disc is the final stage of the create disc process. Once your disc is

burned, you are able to play it on a disc player.

Note: before burning your disc, select Burning > Settings from the menu (or

Ctrl+I on your keyboard) to configure the video settings. See Configuring Video

Settings for more information.

Click on the Burn button and then on Start Burning to begin the burning process.

Note: the burning process may take at least a few minutes, depending on the

length and quality of your video, and your computer’s processing power. Be

prepared for a short wait while CyberLink Power2Go renders your video disc.

Select the Auto shut down after burning option if you want CyberLink

Power2Go to automatically shut down your computer once it has successfully

burned your disc.

Configuring Burn Settings

Before you burn to a disc for the first time, it is advised that you click on to

set your burning settings. After you configure these settings, CyberLink Power2Go

uses the same settings each time you burn until you change them.