Operation Manual

Chapter 2: Power2Go Program
25
Note: the video quality and audio type options that are available depend on the disc
format that you have selected.
•
TV Format: select the TV format (NTSC or PAL) for your video. This format
should correspond to the region in which you plan to play your video disc.
Burning Video to Disc
Burning the disc is the final stage of the create disc process. Once your disc is
burned, you are able to play it on a disc player. Click on the Burn button and then
on Start Burning to begin the burning process.
Note: the burning process may take at least a few minutes, depending on the length
and quality of your video and your computer’s processing power. Be prepared for a
short wait while CyberLink Power2Go renders your video disc.
Configuring Burn Settings
Before you burn to a disc for the first time, it is advised that you click on to
set your burning settings. After you configure these settings, CyberLink
Power2Go
uses the same settings each time you burn until you change them.
Erasing Discs
If you are using a rewritable disc, you can erase content that has data previously
recorded on it. This allows you to reuse the same discs over and over without the
need to continually buy new discs. Click on the button to begin erasing a
disc.
When erasing a disc, select:
• the Quick erase option to erase the disc index contained on the disc.
• the Full erase option to erase all of the content the disc contains.