Operation Manual

38
CyberLink Power2Go
2. Click on to import a CUE file. Browse to the location of the CUE file,
select it, and then click Open to import.
Note: the CUE file's associated audio file must be in the same folder as the
CUE file and have the same file name. The associated audio file can be in
either the FLAC or APE audio file format.
3. Insert your disc and then select your drive in the drop-down list.
4. If required, select a Write speed for the burning disc. The speed you should
select will depend on the burning drives you are using and the quality of the
discs.
5. Enter the Number of copies you want to burn.
6. If available, you can use the following options to assist with the burning
process:
select Perform write simulation if you want CyberLink Power2Go to simulate
the burning process first to ensure the burn will finish successfully.
if available, select Verify recorded data if you want CyberLink Power2Go to
verify that the content was successfully burned to the disc.
if available, select Enable defect management to have CyberLink Power2Go try
to fix any defects on a disc so that content burns correctly.
7. When you are ready to burn the disc, click the Burn button.
Note: select the Auto shut down after burning option if you want
CyberLink Power2Go to automatically shut down your computer once it has
successfully burned your disc.
8. When the burning is complete, select one of the following options in the
window that opens:
Click the View Log link to view the burning log. The log opens in your default
TXT editor, where you can view and save it.
Click Print Label to create a disc label for the disc in CyberLink LabelPrint, if it
is installed on your computer.
Click Capture Label to take a photo snapshot that will be used to help identify
the burned disc it in the Disc Manager*.