Operation Manual

27
Importing Media
Recording Settings
Set your recording settings as follows:
Devices: select the import source, or audio device, you want to use to record
audio with by doing one of the following:
Microphone: select this option and then the microphone from the list if
you want to record from a connected microphone.
What You Hear: select this option to loop back and record the audio that
you are hearing on your computer. Just select from the devices connected
to your computer that is the source of the audio, i.e. sound card, speakers,
etc.
Channels: select the channel (or Stereo if you want it recorded in both
channels) you want the audio recorded to.
Sample rate: set the sample rate of the recorded file by selecting it from the
drop-down.
Bit depth: set the bit depth of the recorded file by selecting it from the drop-
down.
Monitor input: set this option to On if you want to hear the import source
during the recording. If set to Off, you cannot hear the input source during
recording.
Countdown timer: select this option to enable a countdown before CyberLink
AudioDirector begins recording audio. Set the length of the countdown
(maximum 30 seconds) in the field provided.
Click OK to save any changes you make to the recording settings.