User manual

Getting Started
19
Set up the CyberGuard SG appliance’s switch
Note
This page will only display if you are setting up the SG560, SG565 or SG580. Otherwise
skip to the next step.
By default, the CyberGuard SG appliance’s switch A behaves as a conventional
switching hub. However, it may be configured so that each port behaves as if it were
physically separate from the others.
Select a configuration for the CyberGuard SG appliance’s switch then click Next.
 Select 1 LAN Port, 3 Isolated Ports if you require multiple network segments, such
as a DMZ, guest network or second LAN, or if you want to use multiple broadband
Internet connections for Internet load balancing or Internet failover. Port A1 is used
as the primary LAN connection.
Note
For instructions on setting up multiple network segments and Internet connections,
please refer to the next chapter of this manual.
 Otherwise, select 4 LAN Ports.