User manual

Firewall
166
If you have been given a single licence key, you have a subscription to the original
Content system. If you have been given a certificate and private key, you have a
subscription to the new Webwasher system.
Content
Check Enable Content Filtering enter your License key then continue on to set
reporting options and which categories to block. Click Apply once these options have
been set up to enable content filtering.
Checking Enable Cache stores recently accessed pages’ ratings locally, to lower the
response time the next time the page is accessed. It is recommended that you leave this
checked.
Blocked requests are submitted to the central content filtering server. The user
attempting to access blocked content can be identified either through User Accounts
(see User Authentication earlier in this chapter) or the IP Address of their machine.
Click the Reports tab to connect to the central content filtering server. Enter your
Customer ID, Username and Password that were issued with your content filtering
license. Click View Reports.
Warning
The correct time/date must be set on your CyberGuard SG appliance for reporting to
work. The most effective way to do this is by using an NTP time server. See the Time
and Date section in the chapter entitled System for details.
Also note that the username and password is not the same as the one used to access
your CyberGuard SG appliance, check http://www.cyberguard.com/snapgear/my/ for
login details.