Install guide

7
Step 4 – Set up SG's password and LAN connection settings
Launch your Web browser and navigate to 192.168.0.1.
Note: If you are unable to browse to the SG unit at 192.168.0.1, or are not
accepted, reset the SG unit to the factory default by pressing the erase
button on the unit's rear panel twice within 3 seconds, 1 second apart. Wait
20 - 30 seconds, and then try browsing to 192.168.0.1 again.
The SnapGear Management Console page appears.
.
1 Click the Quick Setup Wizard link in the center of the page.
2 A logon prompt is displayed. Enter the initial user name and
password for the SG unit:
– User name: root
– Password: default
3 Click OK. The SG Unit Password page appears.