Install guide

4
Step 1– Unpack the SG unit
In addition to this document, check that you have the following items
included with your SG unit:
• Power cable
• Power adaptor
• SG CD
• Network cable
Take a few minutes to get familiar with the SG unit. On the rear panel of
the SG unit, there are network, serial, and possibly USB ports, an erase
button, and a power inlet.
The front panel of the SG unit contains activity LEDs (lights).The status
LEDs provide information on the operating status of the SG unit.
Step 2 – Power on the SG unit
Connect the power adapter to the SG unit and apply the power. Use
only the power adapter packaged with the unit.
Check the front panel lights, System/Heart Beat (H/B) /TST along with
all other front panel LEDs flash when the SG unit is running.
Note: If these LEDs do not behave in the above manner before your SG
unit is attached to the network, perform a factory reset. Press the erase
button on rear panel twice within three seconds, 1 second apart to restore
factory default settings. If the LEDs are still not flashing after 30 seconds,
you may need to contact customer service.