Install guide

Step 6 – Confirm settings; connect the SG unit to your LAN

Review your configuration selections. If you are satisfied with your

settings, click Finish to activate the new configuration.

Note: If you changed the SG unit's LAN connection settings, you may not

be able to contact it at this point. The following describes how to set up the

PCs on your network to access the SG unit and the Internet.

If you have not already done so, connect the SG unit to your LAN:

• If you are setting up the SG310, connect PCs and/or your LAN hub

directly to its LAN switch.

• If you are setting up the SG560, SG565 or SG580 and have

configured its switch as 4 LAN Ports, connect PCs and/or your LAN

hub directly to switch A.

• If you are setting up the SG560, SG565 or SG580 and have

configured its switch as 1 LAN Port, 3 Isolated Ports, connect port

A1 directly to your LAN hub.

• Otherwise, connect the LAN port directly to your LAN hub.